ASTM A635 PDF
This standard is issued under the fixed designation A /A M; the 1 This specification is under the jurisdiction of ASTM Committee A ASTM A/AM: Standard Specification for Steel, Sheet and Strip, Heavy- Thickness Coils, Hot-Rolled, Alloy, Carbon, Structural. Find the most up-to-date version of ASTM A at Engineering
|Published (Last):||19 April 2015|
|PDF File Size:||19.50 Mb|
|ePub File Size:||7.77 Mb|
|Price:||Free* [*Free Regsitration Required]|
NOTE 2—Micrometers used for measurement of thickness shall be constructed with anvils and spindles having minimum diameters of 0. Carbon Manganese to 0. Note 1—The term weight is used when inch-pound units are the standard.
Your comments are invited either for revision of this standard or for additional standards and should be addressed to ASTM International Headquarters. Over 8 to 12, incl Crown Tolerances for Speci?
A number in parentheses indicates the year of last reapproval. Approved March 1, For nominal thickness, the tolerance is divided equally over and under.
For strip over 8 in. Questions or comments about MatWeb?
ASTM A635 Grade 1018
NOTE 1—Camber is the deviation of a side edge from a straight line. However, unless the order speci? The mechanical property requirements, number of specimens, test locations, and specimen orientation shall be in accordance with the applicable product specification.
These tolerances do not include crown, and, therefore, the tolerances given in Table 9 are in addition to this table.
Steel subjected to certain heating operations by the purchaser may not give chemical analysis results that properly represent its original composition. Click here to view all the property values for this datasheet as they were astk entered into MatWeb.
Such a deviation is ast, by placing a straightedge on the concave side and measuring the greatest distance between the sheet edge and the straightedge. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.
Individual reprints single or multiple copies of this standard may be obtained astj contacting ASTM at the above address or at phonefaxor service astm. Data sheets for overmetals, plastics, ceramics, and composites. The values stated in each system are not 1 This speci? Historical Version s – view previous versions of standard.
AK Steel ASTM A and A Hot Rolled Carbon Steel, Structural Steel (SS)
Such a deviation is obtained by placing a mm straightedge on the concave side and measuring the greatest distance between the strip edge and the straightedge. Notwithstanding the absence of a signature, the organization submitting the EDI transmission is responsible for the content of the report.
Originally approved in Over 8 to 12 A The manufacturer must be consulted. Over 8 to 12, incl A Speci? This standard is subject to revision at any time by the responsible technical committee and must be reviewed every? Conformance to Annex A1 is mandatory when the “M” specification is used.
ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date. Packaging and Package Marking The analysis shall be from a test sample preferably taken during the pouring of the heat or cast. The contents, results, and technical data from this site may not be reproduced either electronically, photographically or substantively without permission from MatWeb, LLC.